IMPREGNATION OF VACUUM CASTING


During the casting process, gases released into the molten metal, and these causes gap of continuity, inclusions, pores, shrinkage cavities in the solidified material. For castings where the liquid or gas-density must be 100%, leads to refuse materials.These parts can be mostly saved efficiently, when the pores are filled in with polymerises plastic by vacuum.

The appearance of pores have three typical types:


 

TYPES OF INCLUSIONS AND PORES

 

The inclusion

 

In good case, there is not a problem. But it may easily occur, when need more proccessing during the treatment of material removing, the inclusions open up and becomes a blind pore or through pore.


The blind pore


Generally, this is a non-permeable, but depending on the thickness of the wall the internal corrosion can easily break through the thinnest point. It’s also disadvantageous because of the retention of contamination.


Through pore


It causes most of the problems. Often invisible, the leak can appreciable only under pressure.

 


WHY VACUUM SEALING?


Frequently the size of the pores are microns but in the millimeter wide channels or blind pores the sealant is not absorbed into, because of the air opposition and viscosity of the sealant inside. In the vacuum sealing, we take the pieces around with vacuum, and then we filling into the sealing liquids. As a result of pressure, the pores absorb and keep in the sealant.

 

WHY POLYMERIZATED MATERIAL?

 

The pores can keep the material, but under pressure there is no significant opposition. The ULTRASEAL company has developed a group of materials, which can change under heat-treatment, and become as a flexible solid material and  resist of pressure, vibration and chemical effects. All significant quality control company and users tested and approved these materials.

 

 

Microscopic picture of a cross section of castings.

 

 

Hungaromarket, as the Hungarian representative of the company of ULTRASEAL, has the appropriate equipment materials and licenses to conduct this process. Our specialty, next to the typical small parts, is the vacuum impregnation of large pieces as well. (e.g.: pump- house)

 


The simplified process of impregnation.

 

 

TYPICAL AND SPECIFIC PIECES OF WAGE-WORK OF HUNGAROMARKET

 

Parts of Gas meter equipment, Air conditioning components, Brake parts, Engine blocks, Pump houses, Water fittings and Pressure vessels, and also restoration of metal and wooden antiquities.

 

 

 

REFERENCES OF OUR TECHNOLOGY

 

Delphi, Knorr-Bremse, Visteon, VT Metal, LeBelier, Linamar, Nemak, Csabacast, Grundfos, Fémalk, Bosh, Kludi, etc.

 

For more information contact us by e-mail, phone, fax or write us on the given contact addresses.